My 6-string banjo (Banjitar) bridge is thicker than a normal banjo so the only way the pickup fits is if I remove the rubber sleeve all together. Is this, ok?? Is it necessary to have that sleeve on? Does removing that sleeve effect the way it works?

Date: 12.06.2024

Absolutely, you can totally remove the sleeve and the BP-1 will still work great. Without the sleeve, you may need to use the provided shims in case the element goes the other way and is now too wide. Just remember to install it on the upper part of the bridge and then slide it down until it fits snugly, and don’t be hesitant to try it on either side of the bridge!

More FOLK INSTRUMENTS PICKUPS QUESTIONS

My 6-string banjo (Banjitar) bridge is thicker than a normal banjo so the only way the pickup fits is if I remove the rubber sleeve all together. Is this, ok?? Is it necessary to have that sleeve on? Does removing that sleeve effect the way it works?

Will a MP2 pickup work with a Behringer X18 board? Do I need to use one of the two high impedance channels on the X-18 (100 K Ohm vs 10 K "normal" channels)? Do I need to use an ultra-high impedance DI box (1 meg ohm)?

What are the minimum and maximum clearance measurements for the MP-2 pickup? I'm referring to the distance from the bottom of the saddle to the top bridge body?

I play a Loar LM-590 mandolin. The gap in the bridge is too large, even with the included shims. Additionally, I tried the gap between the body and the bridge which is too small. Are there any other solutions? Is there an internal mounting option?